New Constraints on Temperature, Oxygen Fugacity and H2O of Subduction Zone Basalts Based on Olivine-Melt Equilibrium
Pu, Xiaofei
2018
Abstract
Erupted basalts are windows into the deep Earth. This dissertation provides evidence that mantle-derived basalts grow their phenocrysts during rapid ascent to the surface, and that the most Mg-rich olivine in erupted samples approximates the first mineral to crystallize from a liquid with a composition of the whole rock. This presents opportunities to constrain the temperature, oxidation state and water content of these basalts on the basis of olivine-melt equilibrium. Chapter II develops a new olivine-melt thermometer based on the partitioning of Ni (DNiol/liq), and provides evidence that it is far less sensitive to the effects of pressure and dissolved H2O in the melt than DMgol/liq, which is the basis of most olivine-melt thermometers in the literature. The application of both thermometers to a set of subduction-zone basalts allows the depression of the olivine liquidus due to the effect of dissolved water to be determined based on the different temperatures calculated from the two thermometers; a minimum H2O content in the melt at the onset of olivine crystallization can be determined. Chapter III investigates the sensitivity of DNiol/liq to dissolved H2O in basaltic melts through a series of olivine-melt equilibrium experiments. Four 1-bar experiments, one anhydrous experiment at 0.5 GPa, and five hydrous experiments at 0.5 GPa are presented. The Ni-thermometer developed in Chapter II recovers the experimental temperature for all ten experiments within 14˚C on average, including those where the melt contained at least 4.4 wt% H2O. In contrast, the Mg-thermometer (Chapter II) recovers the Texpt of the anhydrous experiments within error (±26˚C), but overestimates Texpt by 88-141˚C for the hydrous experiments. The results shows a negligible dependence of DNiol/liq on pressure and dissolved water under crustal conditions, which confirms that the olivine-melt Ni-thermometer can be applied to hydrous basalts at <1 GPa without corrections for H2O content in the melt and pressure. Chapter IV applies the new Ni-based olivine-melt thermometer developed and tested in Chapter II and III to a set of mantle-derived, high-K melts that erupted within the Colima rift in western Mexico, where a mid-ocean spreading ridge is interacting with a subduction zone. Application of the Ni-thermometer, together with phase-equilibrium experiments on phlogopite lherzolite from the literature, shows that the K-rich Colima melts segregated near the base of the relatively thick lithosphere of the Jalisco block at relatively high pressures (~2.5 GPa) compared to most subduction-zone melts (~1.5 GPa). These temperatures and pressures of melt segregation provide key constraints on geodynamic models of this complex tectonic setting. Chapter V investigates the cause of the relatively high oxygen fugacity (fO2) of the pristine K-rich Colima lavas (Chapter IV). The pre-eruptive oxidation state (Fe3+/Fe2+ ratio), derived from olivine-melt Fe2+-Mg exchange equilibrium, indicate fO2 values that are ~2 log units lower than the post-eruptive value; yet they are still significantly higher than those found in most terrestrial basalts. This elevated pre-eruptive fO2 leads to higher solubility of sulfate in the melt, which degasses as SO2 and H2S, and drives melt oxidation. This is the first documentation of sulfur degassing-induced oxidation observed in natural samples.Subjects
basalt subduction zone processes temperature olivine-melt equilibrium melt H2O content oxygen fugacity
Types
Thesis
Metadata
Show full item recordCollections
Remediation of Harmful Language
The University of Michigan Library aims to describe library materials in a way that respects the people and communities who create, use, and are represented in our collections. Report harmful or offensive language in catalog records, finding aids, or elsewhere in our collections anonymously through our metadata feedback form. More information at Remediation of Harmful Language.
Accessibility
If you are unable to use this file in its current format, please select the Contact Us link and we can modify it to make it more accessible to you.