Performance-Driven Energy-Efficient VLSI.

Abstract

Today, there are two prevalent platforms in VLSI systems: high-performance and ultra-low power. High-speed designs, usually operating at GHz level, provide the required computation abilities to systems but also consume a large amount of power; microprocessors and signal processing units are examples of this type of designs. For ultra-low power designs, voltage scaling methods are usually used to reduce power consumption and extend battery life. However, circuit delay in ultra-low power designs increases exponentially, as voltage is scaled below Vth, and subthreshold leakage energy also increases in a near-exponential fashion. Many methods have been proposed to address key design challenges on these two platforms, energy consumption in high-performance designs, and performance/reliability in ultra-low power designs. In this thesis, charge-recovery design is explored as a solution targeting both platforms to achieve increased energy efficiency over conventional CMOS designs without compromising performance or reliability. To improve performance while still achieving high energy efficiency for ultra-low power designs, we propose Subthreshold Boost Logic (SBL), a new circuit family that relies on charge-recovery design techniques to achieve order-of-magnitude improvements in operating frequencies, and achieve high energy efficiency compared to conventional subthreshold designs. To demonstrate the performance and energy efficiency of SBL, we present a 14-tap 8-bit finite-impulse response (FIR) filter test-chip fabricated in a 0.13µm process. With a single 0.27V supply, the test-chip achieves its most energy efficient operating point at 20MHz, consuming 15.57pJ per cycle with a recovery rate of 89% and a FoM equal to 17.37 nW/Tap/MHz/InBit/CoeffBit. To reduce energy consumption at multi-GHz level frequencies, we explore the application of resonant-clocking to the design of a 5-bit non-interleaved resonant-clock ash ADC with a sampling rate of 7GS/s. The ADC has been designed in a 65nm bulk CMOS process. An integrated 0.77nH inductor is used to resonate the entire clock distribution network to achieve energy efficient operation. Operating at 5.5GHz, the ADC consumes 28mW, yielding 396fJ per conversion step. The clock network accounts for 10.7% of total power and consumes 54% less energy over CV^2. By comparison, in a typical ash ADC design, 30% of total power is clock-related.